Dell S4148U-ON OS10 Enterprise Edition User Guide Release 10.4.0E R2 - Page 357

Example OS10(conf-if-eth1/1/6)# ip ospf passive Supported Releases 10.2.0E or later ip ospf priority Sets the priority of the interface to determine the designated router for the OSPF network. Syntax Parameters Default Command Mode Usage Information Example ip ospf priority number number - Enter a router priority number (0 to 255). 1 INTERFACE When two routers attached to a network attempt to become the designated router, the one with the higher router priority takes precedence. The no version of this command resets the value to the default. OS10(conf-if-eth1/1/6)# ip ospf priority 4 Supported Releases 10.2.0E or later ip ospf retransmit-interval Sets the retransmission time between lost LSAs for adjacencies belonging to the interface. Syntax ip ospf retransmit-interval seconds Parameters seconds - Enter a value in seconds as the interval between retransmission (1 to 3600). Default 5 seconds Command Mode INTERFACE Usage Information Set the time interval to a number large enough to avoid unnecessary retransmission. The no version of this command resets the value to the default. Example OS10(conf-if-eth1/1/6)# ip ospf retransmit-interval 20 Supported Releases 10.2.0E or later ip ospf transmit-delay Sets the estimated time required to send a link state update packet on the interface. Syntax ip ospf transmit-delay seconds Parameters seconds - Set the time (in seconds) required to send a link-state update (1 to 3600). Default 1 second Command Mode INTERFACE Usage Information Set the estimated time required to send a link-state update packet. When you set the ip ospf transmitdelay value, take into account the transmission and propagation delays for the interface. The no version of this command resets the value to the default. Example OS10(conf-if-eth1/1/4)# ip ospf transmit-delay 5 Supported Releases 10.2.0E or later Layer 3 357