Dell S4148U-ON OS10 Enterprise Edition User Guide Release 10.4.0E R2 - Page 87
Forward error correction, Energy-efficient Ethernet, Energy-efficient
![]() |
View all Dell S4148U-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
OS10(config)# do show running-configuration interface fibrechannel 1/1/1 interface fibrechannel1/1/1 shutdown Forward error correction Forward error correction (FEC) is used to enhance data reliability. FEC modes supported in OS10: • CL74-FC - Supports 25G and 50G • CL91-RS - Supports 100G • CL108-RS - Supports 25G and 50G • off - Disables FEC NOTE: OS10 does not support FEC on 10G and 40G. Configure FEC OS10(config)# interface ethernet 1/1/41 OS10(conf-if-eth1/1/41)# fec CL91-RS View FEC configuration OS10# show interface ethernet 1/1/41 Ethernet 1/1/41 is up, line protocol is up Hardware is Dell EMC Eth, address is e4:f0:04:3e:1a:06 Current address is e4:f0:04:3e:1a:06 Pluggable media present, QSFP28 type is QSFP28_100GBASE_CR4_2M Wavelength is 64 Receive power reading is Interface index is 17306108 Internet address is not set Mode of IPv4 Address Assignment: not set Interface IPv6 oper status: Disabled MTU 1532 bytes, IP MTU 1500 bytes LineSpeed 100G, Auto-Negotiation on FEC is cl91-rs, Current FEC is cl91-rs Flowcontrol rx off tx off ARP type: ARPA, ARP Timeout: 60 Last clearing of "show interface" counters: 00:00:17 Queuing strategy: fifo Input statistics: 7 packets, 818 octets 2 64-byte pkts, 0 over 64-byte pkts, 5 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 7 Multicasts, 0 Broadcasts, 0 Unicasts 0 runts, 0 giants, 0 throttles 0 CRC, 0 overrun, 0 discarded Output statistics: 15 packets, 1330 octets 10 64-byte pkts, 0 over 64-byte pkts, 5 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 15 Multicasts, 0 Broadcasts, 0 Unicasts 0 throttles, 0 discarded, 0 Collisions, 0 wred drops Rate Info(interval 30 seconds): Input 0 Mbits/sec, 0 packets/sec, 0% of line rate Output 0 Mbits/sec, 0 packets/sec, 0% of line rate Time since last interface status change: 00:00:13 --more-- Energy-efficient Ethernet Energy-efficient Ethernet (EEE) reduces power the consumption of physical layer devices (PHYs) during idle periods. EEE allows Dell Networking devices to conform to green computing standards. Interfaces 87
![](/manual_guide/products/dell-s4148uon-os10-enterprise-edition-user-guide-release-1040e-r2-86f2ab4/87.png)