Dell S4148U-ON OS10 Enterprise Edition User Guide Release 10.4.0E R2 - Page 386
ipv6 ospf encryption, ipv6 ospf hello-interval, Configures, prefix., first
![]() |
View all Dell S4148U-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 386 highlights
ipv6 ospf encryption Configures OSPFv3 encryption on an IPv6 interface. Syntax ipv6 ospf encryption ipsec spi number esp encryption-type key authenticationtype key Parameters • area area-id - Enter an area ID as a number or IPv6 prefix. • ipsec spi number - Enter a unique security policy index number (256 to 4294967295). • esp encryption-type - Enter the encryption algorithm used with ESP (3DES, DES, AES-CBC, or NULL). For AES-CBC, only the AES-128 and AES-192 ciphers are supported. • key - Enter the text string used in the encryption algorithm. • authentication-type - Enter the encryption authentication algorithm to use (MD5 or SHA1). • key - Enter the text string used in the authentication algorithm. Default Command Mode Usage Information IPv6 OSPF encryption is not configured on an interface. INTERFACE • Before you enable IPsec authentication on an OSPFv3 interface, you must enable IPv6 unicast routing globally, configure an IPv6 address and enable OSPFv3 on the interface, and assign it to an area. • When you configure encryption on an interface, both IPsec encryption and authentication are enabled. You cannot configure encryption if you have already configured an interface for IPsec authentication (ipv6 ospf authentication ipsec). To configure encryption, you must first delete the authentication policy. • All neighboring OSPFv3 routers must share the same encryption key to decrypt information. Only a nonencrypted key is supported. Required lengths of the non-encrypted key are: 3DES - 48 hex digits; DES - 16 hex digits; AES-CBC - 32 hex digits for AES-128 and 48 hex digits for AES-192. • All neighboring OSPFv3 routers must share the same authentication key to exchange information. Only a nonencrypted key is supported. For MD5 authentication, the non-encrypted key must be 32 plain hex digits. For SHA-1 authentication, the non-encrypted key must be 40 hex digits. An encrypted key is not supported. Example OS10(config)# interface ethernet 1/1/6 OS10(conf-if-eth1/1/6)# ipv6 ospf encryption ipsec spi 500 esp des 1234567812345678 md5 12345678123456781234567812345678 Supported Releases 10.4.0E(R1) or later ipv6 ospf hello-interval Sets the time interval between hello packets sent on an interface. Syntax ipv6 ospf hello-interval seconds Parameters seconds - Enter the hello-interval value in seconds (1 to 65535). Default 10 seconds Command Mode INTERFACE Usage Information All routers in a network must have the same hello time interval between the hello packets. The no version of the this command resets the value to the default. Example OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# ipv6 ospf hello-interval 30 386 Layer 3
![](/manual_guide/products/dell-s4148uon-os10-enterprise-edition-user-guide-release-1040e-r2-86f2ab4/386.png)