Dell S4148U-ON OS10 Enterprise Edition User Guide Release 10.4.0E R2 - Page 356

Example OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ip ospf message-digest-key 2 md5 sample12345 Supported Releases 10.3.0E or later ip ospf mtu-ignore Disables OSPF MTU mismatch detection on receipt of DBD packets. Syntax ip ospf mtu-ignore Parameters None Default Not configured Command Mode INTERFACE Usage Information When neighbors exchange DBD packets, the OSPF process checks if the neighbors are using the same MTU on a common interface. If the receiving MTU in the DBD packet is higher than the IP MTU configured on the incoming interface, OSPF adjacency does not establish. The no version of this command enables the IP OSPF mtu-ignore configuration. Example OS10(conf-if-vl-10)# ip ospf mtu-ignore Supported Releases 10.2.0E or later ip ospf network Sets the network type for the interface. Syntax ip ospf network {point-to-point | broadcast} Parameters • point-to-point - Sets the interface as part of a point-to-point network. • broadcast - Sets the interface as part of a broadcast network. Default Command Mode Usage Information Example Broadcast INTERFACE The no version of this command resets the value to the default. OS10(conf-if-eth1/1/1)# ip ospf network broadcast Supported Releases 10.2.0E or later ip ospf passive Configures an interface as a passive interface and suppresses routing updates (both receiving and sending) to the passive interface. Syntax Parameters Default Command Mode Usage Information ip ospf passive None Not configured INTERFACE You must configure the interface before setting the interface to Passive mode. The no version of the this command disables the passive interface configuration. 356 Layer 3