Dell S4148U-ON OS10 Enterprise Edition User Guide Release 10.4.0E R2 - Page 524
seq permit (IPv6), seq permit (MAC
![]() |
View all Dell S4148U-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 524 highlights
seq permit (IPv6) Assigns a sequence number to permit IPv6 packets, while creating a filter. Syntax seq sequence-number permit protocol-number [A::B | A::B/x | any | host ipv6address] [A::B | A:B/x | any | host ipv6-address] [capture | count [byte] | dscp value | fragment] Parameters • sequence-number - Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214. • protocol-number - (Optional) Enter the protocol number, from 0 to 255. • A::B - Enter the IPv6 address in hexadecimal format separated by colons. • A::B/x - Enter the number of bits that must match the IPv6 address. • any - (Optional) Set all routes which are subject to the filter: • capture - (Optional) Enter to capture packets the filter processes. • count - (Optional) Enter to count packets the filter processes. • byte - (Optional) Enter to count bytes the filter processes. • dscp value - (Optional) Enter the DSCP value to permit a packet, from 0 to 63. • fragment - (Optional) Enter to use ACLs to control packet fragments. • host ipv6-address - (Optional) Enter the IPv6 address to be used as the host address. Default Command Mode Usage Information Example Not configured IPV6-ACL OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# seq 10 permit ipv6 any any capture session 1 count Supported Releases 10.2.0E or later seq permit (MAC) Assigns a sequence number to permit MAC addresses while creating a filter. Syntax seq sequence-number permit {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture | cos | count [byte] | vlan] Parameters • sequence-number - Enter the sequence number to identify the route-map for editing and sequencing, from 1 to 16777214. • nn:nn:nn:nn:nn:nn - Enter the MAC address of the network from or to which the packets were sent. • 00:00:00:00:00:00 - (Optional) Enter which bits in the MAC address must match. If you do not enter a mask, a mask of 00:00:00:00:00:00 applies. • any - (Optional) Set all routes to be subject to the filter: • protocol-number - (Optional) Enter the protocol number identified in the MAC header, from 600 to ffff. 524 Access Control Lists
![](/manual_guide/products/dell-s4148uon-os10-enterprise-edition-user-guide-release-1040e-r2-86f2ab4/524.png)