Dell S4148U-ON OS10 Enterprise Edition User Guide Release 10.4.0E R2 - Page 33
Candidate configuration, Candidate
View all Dell S4148U-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
-- Unit 1 -Status System Identifier Down Reason System Location LED Required Type Current Type Hardware Revision Software Version Physical Ports BIOS System CPLD Master CPLD Slave CPLD : up : 1 : : off : S4048 : S4048 : : 10.3.9999E(X) : 48x10GbE, 6x40GbE : 3.21.0.4 : 15 : 12 : 5 -- Power Supplies -- PSU-ID Status Type AirFlow Fan Speed(rpm) Status 1 fail 2 up AC REVERSE 1 14720 up -- Fan Status -- FanTray Status AirFlow Fan Speed(rpm) Status 1 up REVERSE 1 13063 up 2 13063 up 2 up REVERSE 1 13020 up 2 12977 up 3 up NORMAL 1 13085 up 2 13063 up Candidate configuration When you enter OS10 configuration commands in the transaction-based configuration mode, changes do not take effect immediately and are stored in the candidate configuration. The configuration changes become active on the network device only after you commit the changes with the commit command. Changes in the candidate configuration are validated and applied to the running configuration. The candidate configuration allows you to avoid introducing errors during an OS10 configuration session. You can make changes and then check them before committing them to the active, running configuration on the network device. Use the show diff command to check differences between the running configuration and the candidate configuration. After comparing the two, you can decide if you would like to commit the changes to the running configuration. Use the discard command to delete uncommitted changes. • Enter show ? from EXEC mode to view a list of commands to monitor a device. OS10# show ? aaa access-list as-path bgp class-map community-list compressed control-plane dot1x extcommunity-list interface lacp lldp logging monitor Current candidate aaa configuration Current candidate access-list configuration Current candidate as-path configuration Current candidate bgp configuration Current candidate class-map configuration Current candidate community-list configuration Current candidate configuration in compressed format Current candidate control-plane configuration Current candidate dot1x configuration Current candidate extcommunity-list configuration Current candidate interface configuration Current candidate lacp configuration Current candidate lldp configuration Current candidate logging configuration Current candidate monitor session configuration Getting Started 33