Dell S4148U-ON OS10 Enterprise Edition User Guide Release 10.4.0E R2 - Page 321
ipv6 address link-local, ipv6 hop-by-hop, Parameters, Defaults, Command Mode, Usage Information
![]() |
View all Dell S4148U-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 321 highlights
Parameters Defaults Command Mode Usage Information Example ipv6-prefix - Enter an IPv6 prefix in x:x::y/mask format. None INTERFACE Use this command to manually configure an IPv6 address in addition to the link-local address generated with stateless autoconfiguration. Specify only the network prefix and length. The 64-bit interface ID is automatically computed from the MAC address. This command enables IPv6 processing on the interface. The no version of this command removes the IPv6 address configuration. OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# ipv6 address 2111:dddd:0eee::/64 eui-64 Supported Releases 10.4.0E(R1) or later ipv6 address link-local Configures a link-local IPv6 address on the interface to use instead of the link-local address that is automatically configured with stateless autoconfiguration. Syntax Parameters Defaults Command Mode Usage Information ipv6 address ipv6-prefix link-local ipv6-prefix - Enter an IPv6 prefix in x:x::y/mask format. None INTERFACE • An interface can have only one link-local address. By default, an IPv6 link-local address is automatically generated with a MAC-based EUI-64 interface ID when a router boots up and IPv6 is enabled. Use this command to manually configure a link-local address to replace the autoconfigured address. For example, to configure a more user-friendly link-local address, replace fe80::eef4:bbff:fefb:fa30/64 with fe80::1/64. • The no version of this command removes the specified link-local address. Example OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# ipv6 address 2111:dddd:0eee::22/64 link-local Supported Releases 10.4.0E(R1) or later ipv6 hop-by-hop Enables and disables processing hop-by-hop options in IPv6 packet headers. Syntax ipv6 hop-by-hop Parameters None Defaults Hop-by-hop header options in an IPv6 packet are not processed on an interface. Command Mode INTERFACE Usage Information • Use this command to enable local processing of IPv6 packets with hop-by-hop options in conformance with RFC 8200, IPv6 Specification. • The no version of this command disables IPv6 processing of hop-by-hop header options. Layer 3 321
![](/manual_guide/products/dell-s4148uon-os10-enterprise-edition-user-guide-release-1040e-r2-86f2ab4/321.png)