Dell S4148U-ON OS10 Enterprise Edition User Guide Release 10.4.0E R2 - Page 26

Remote access Linux shell ssh linuxadmin@ip-address password: linuxadmin Configure Management IP address To remotely access OS10, assign an IP address to the Management port. 1 Configure the management interface from CONFIGURATION mode. interface mgmt node/slot/port 2 Configure an IPv4 or IPv6 address on the Management interface in INTERFACE mode. ip address A.B.C.D/mask ipv6 address A:B/prefix-length 3 Enable the Management interface in INTERFACE mode. no shutdown Configure Management interface OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24 OS10(conf-if-ma-1/1/1)# no shutdown Management Route Configuration WARNING: Avoid configuring an IPv4 or IPv6 address and a static route for the management interface that conflict with an IPv4 or IPv6 address and static route on a front-end port interface. To set up remote access to OS10, configure a management route after you assign an IPv4 or IPv6 address to the Management port. The default management route is the path used by a Management port to communicate with a different network. Management routes are separate from IPv4 and IPv6 routes and are only used to manage the system through the Management port. management route 192.168.100.0/24 1.1.1.1 ip route 192.168.100.0/24 2.2.2.2 management route 192.168.200.0/24 managementethernet ip route 192.168.200.0/24 interface ethernet 1/1/1 Configure a management route to the network from which you access the system in CONFIGURATION mode. Repeat the command to configure multiple routes for the Management interface. management route {ipv4-address/mask | ipv6-address/prefix-length} {forwarding-router-address | managementethernet} • ipv4-address/mask - Enter an IPv4 network address in dotted-decimal format (A.B.C.D), then a subnet mask in /prefix-length format (/xx). • ipv6-address/prefix-length - Enter an IPv6 address in x:x:x:x::x format with the prefix length in /x format (prefix range is /0 to /128). • forwarding-router-address - Enter the next-hop IPv4/IPv6 address of a forwarding router for network traffic from the Management port. • managementethernet - Configures the Management port as the interface for the route, and forces the route to be associated with the Management interface. Configure management route OS10(config)# management route 10.10.20.0/24 10.1.1.1 OS10(config)# management route 172.16.0.0/16 managementethernet 26 Getting Started