Dell S4148U-ON OS10 Enterprise Edition User Guide Release 10.4.0E R2 - Page 412

Create virtual router VRRP uses the VRID to identify each virtual router configured. Before using VRRP, you must configure the interface with the primary IP address and enable it. • Create a virtual router for the interface with the VRRP identifier in INTERFACE mode (1 to 255). vrrp-group vrrp-id • Delete a VRRP group in INTERFACE mode. no vrrp-group vrrp-id Configure VRRP OS10(config)# interface ethernet 1/1/5 OS10(conf-if-eth1/1/5)# vrrp-group 254 Verify VRRP OS10(conf-eth1/1/5-vrid-254)# do show running-configuration ... ! interface ethernet 1/1/5 ip address 10.10.10.1/24 ! vrrp-group 254 no shutdown ... Group version Configure a VRRP version for the system. Define either VRRPv2 - version 2, VRRPv3 - version 3, or version both to migrate a system from VRRPv2 to VRRPv3. • Configure the VRRP version for IPv4 in INTERFACE mode. version Configure Version 3 OS10(config)# version 3 Use the version both command in Configuration mode to migrate from VRRPv2 to VRRPv3. When you set the VRRP version to version both, the switch sends and receives both VRRPv2 or VRRPv3 packets. 1 Set the switch with the lowest priority to version both. 2 Set the switch with the highest priority to version 3. 3 Set all switches from version both to version 3. Migrate IPv4 group from VRRPv2 to VRRPv3 OS10_backup_switch1(config)# version both OS10_backup_switch2(config)# version both Set master switch to VRRPv3 OS10_master_switch(config)# version 3 412 Layer 3