Dell S4148U-ON OS10 Enterprise Edition User Guide Release 10.4.0E R2 - Page 344

router ospf 100 ... Assign router identifier For managing and troubleshooting purposes, you can assign a router ID for the OSPFv2 process. Use the router's IP address as the router ID. • Assign the router ID for the OSPFv2 process in ROUTER-OSPF mode router-id ip-address Assign router ID OS10(config)# router ospf 10 OS10(conf-router-ospf-10)# router-id 10.10.1.5 View OSPFv2 status OS10# show ip ospf 10 Routing Process ospf 10 with ID 10.10.1.5 Supports only single TOS (TOS0) routes It is an Autonomous System Boundary Router It is Flooding according to RFC 2328 Convergence Level 0 Min LSA origination 0 msec, Min LSA arrival 1000 msec Min LSA hold time 5000 msec, Max LSA wait time 5000 msec Number of area in this router is 1, normal 1 stub 0 nssa 0 Area (0.0.0.0) Number of interface in this area is 3 SPF algorithm executed 38 times Area ranges are Stub areas Type 5 LSAs are not flooded into stub areas. The ABR advertises a default route into the stub area to which it is attached. Stub area routers use the default route to reach external destinations. 1 Enable OSPF routing and enter ROUTER-OSPF mode, from 1 to 65535. router ospf instance number 2 Configure an area as a stub area in ROUTER-OSPF mode. area area-id stub [no-summary] • area-id-Enter the OSPF area ID as an IP address (A.B.C.D) or number, from 1 to 65535. • no-summary-(Optional) Enter to prevent an ABR from sending summary LSA to the stub area. Configure stub area OS10(config)# router ospf 10 OS10(conf-router-ospf-10)# area 10.10.5.1 stub View stub area configuration OS10(conf-router-ospf-10)# do show ip ospf database OSPF Router with ID (111.2.1.1) (Process ID 10) Router (Area 0.0.0.0) Link ID 111.2.1.1 111.111.111.1 111.111.111.2 112.2.1.1 ADV Router 111.2.1.1 111.111.111.1 111.111.111.2 112.2.1.1 Age 1281 1430 1430 1282 Seq# 0x8000000d 0x8000021a 0x8000021a 0x8000000b Checksum 0x9bf2 0x515a 0x5552 0x0485 Link count 3 1 1 3 344 Layer 3