Fujitsu 6240 User Manual - Page 111
Cleaning the Inside, Cleaning the ADF (with Cleaning Paper)
UPC - 097564307270
View all Fujitsu 6240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Chapter 6 Daily Care 6.3 Cleaning the Inside Cleaning the ADF (with Cleaning Paper) The ADF can be cleaned with a sheet of Cleaning Paper moistened with Cleaner F1. As the scanner continues to feed the documents, paper dust will accumulate inside the ADF and it may cause scanning errors. Cleaning should be performed approximately every 5,000 sheets scanned. Note that this guideline varies depending on the types of documents you scan. For instance, it may be necessary to clean the scanner more frequently when you scan documents on which the toner is not sufficiently fused. ʂ z Do not use water or mild detergent to clean the ADF. z It may take a long time to dry if an excessive amount of Cleaner F1 is used. Use it in small quantity. 1 Turn on the scanner. For details, refer to "1.3 Turning the Power ON/OFF" (page 23). 2 Spray the Cleaning Paper with Cleaner F1. 3 Pull out the chute extensions according to the length of the Cleaning Paper. For details, refer to "1.6 Setting Up the ADF Paper Chute" (page 26). 4 Lift the stacker and stacker extension according to the length of the Cleaning Paper. For details, refer to "1.7 Setting Up the Stacker" (page 27). 5 Load the Cleaning Paper in the ADF paper chute. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings 6 Adjust the side guides to the width of the Cleaning Paper. Do not leave space between the side guides and the Cleaning Paper. Otherwise, the Cleaning Paper may be fed skewed. How to Use the Operator Panel Various Ways to Scan Side guide Daily Care Replacing the Consumables Troubleshooting 7 Start up an application for scanning and perform a scan. For details about the scanning procedure in ScandAll PRO, refer to "ScandAll PRO V2.0 User's Guide". Operational Settings Appendix Glossary 111