Fujitsu 6240 User Manual - Page 182
Specifying the Area to Detect Multifeed [Document check area specification for Multifeed Detection]
UPC - 097564307270
View all Fujitsu 6240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
Chapter 9 Operational Settings Specifying the Area to Detect Multifeed [Document check area specification for Multifeed Detection] The following setting is only available when you specified [Check Overlapping (Ultrasonic)] or [Check Overlapping and Length]. 1 From the listing on the left, select [Device Setting 2] J [Document check area specification for Multifeed Detection]. Select the [Selected range] check box in the dialog box. 2 Specify the detection range. Range Description Selected range Select the check box to specify the detection range (colored in light blue) in the picture below. Middle 35 Range Document TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings Feed direction Disable (Middle) Enable (Middle) Start (Middle) End (Middle) Unit: mm Select the check box to enable the setting in this dialog box. Clear the check box to disable the setting. Clearing this check box sets both start and end positions to "0", making the whole document to be detected for multifeeds. The above condition applies when the document is set to the center of the pick roller width. Does not detect multifeeds for the selected area. Detects multifeeds for the selected area. How to Use the Operator Panel Various Ways to Scan Daily Care Replacing the Consumables Displays the start position of the detection by the length from the leading edge of the document. Range: 0 to 510 mm, in 2 mm increments, Start