Fujitsu 6240 User Manual - Page 206
Patch code, Pick roller, Pick start time, Pixel, Portrait, Pre-pick, Resolution
UPC - 097564307270
View all Fujitsu 6240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 206 highlights
Glossary Patch code A special code to let the scanner recognize the start and the end of each job or image mode. Pick roller A set of rollers which separates one sheet off the documents loaded in the ADF paper chute, and feeds the document into the ADF. Pick start time The period of time between setting the document and until picking starts after the document passes the hopper empty sensor. Pixel The dots that make up a scanned image. Portrait Orientation in which the long side of the document is set parallel to the feed direction. Documents/images are set/displayed vertically. Pre-pick Refers to feeding the document in advance to the position to start scanning. It shortens the interval between setting the document and feeding the document to the starting position. R Resolution A measurement to indicate the quality (fineness) or an image. Resolution is displayed by the number of pixels within an inch. Since image data is a collection of small dots (pixels), if the same image contains different amount of pixels, the one with more pixels can express greater details. Therefore, the higher the resolution, the finer the image becomes. S SCSI SCSI (Small Computer System Interface) is a standard for interfaces, used to connect devices such as hard disks and scanners. Up to seven devices can be connected by this interface (daisy chain). The data transfer rate is 10 MB/sec. at maximum for Fast SCSI, and 20 MB/sec. at maximum for Wide SCSI. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 206