Fujitsu 6240 User Manual - Page 129

Chapter 8 Troubleshooting ■Motor circuit error "H" and "alarm number" are displayed back and forth. Display Item H0 Motor circuit error H6 Imprinter system malfunction H7 Lamp circuit error H8 Motor circuit error (background switching mechanism) Resolution Turn the scanner off then back on. If the problem persists, write down the displayed error code and contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider. ■Option error (when imprinter is installed) "A" and "alarm number" are displayed back and forth. Display Item A0 Imprinter error (control board) A1 Imprinter error (communication time-out) A2 Imprinter error (print head) A3 Imprinter error (EEPROM) A4 Imprinter error (ROM) Resolution 1 Confirm that the EXT cable of the imprinter is connected properly to the EXT connector on the back of the scanner. For details, refer to the fi-614PR Operator's Guide. 2 Confirm that the print cartridge is installed correctly. For details, refer to the fi-614PR Operator's Guide. 3 Turn the scanner off then back on. If the problem persists, write down the displayed error code and contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider. ■Sensor error "L" and "alarm number" are displayed back and forth. Display Item Resolution L6 Sensor error 1 Clear any dust around the ultrasonic sensors. 2 Turn the scanner off then back on. If the problem persists, write down the displayed error code and contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 129