Fujitsu MPD3173AT Product Manual - Page 32
Mounting, Orientation
View all Fujitsu MPD3173AT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
3.2 Mounting (1) Orientation Figure 3.2 illustrates normal orientation for the disk drive. The disk drives can be mounted in any orientation. Horizontal mounting with the PCB facing down Figure 3.2 Orientation (2) Frame The disk enclosure (DE) body is connected to signal ground (SG) and the mounting frame is also connected to signal ground. These are electrically shorted. Note: Use No.6-32UNC screw for the mounting screw and the screw length should satisfy the specification in Figure 3.4. (3) Limitation of side-mounting When the disk drive is mounted using the screw holes on both side of the disk drive, use two screw holes shown in Figure 3.3. Do not use the center hole. For screw length, see Figure 3.4. C141-E069-02EN 3 - 3
C141-E069-02EN
3 - 3
3.2
Mounting
(1)
Orientation
Figure 3.2 illustrates normal orientation for the disk drive.
The disk drives can be mounted in
any orientation.
Horizontal mounting with the PCB facing down
Figure 3.2
Orientation
(2)
Frame
The disk enclosure (DE) body is connected to signal ground (SG) and the mounting frame is
also connected to signal ground.
These are electrically shorted.
Note:
Use No.6-32UNC screw for the mounting screw and the screw length should satisfy the
specification in Figure 3.4.
(3)
Limitation of side-mounting
When the disk drive is mounted using the screw holes on both side of the disk drive, use two
screw holes shown in Figure 3.3.
Do not use the center hole.
For screw length, see Figure 3.4.