Fujitsu MPD3173AT Product Manual - Page 55
Execution timing of self-calibration, Table 4.1, Self-calibration execution timechart, Command
![]() |
View all Fujitsu MPD3173AT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
4.5.2 Execution timing of self-calibration Self-calibration is executed when: • The power is turned on. • The disk drive receives the RECALIBRATE command from the host. • The self-calibration execution timechart of the disk drive specifies self-calibration. The disk drive performs self-calibration according to the timechart based on the time elapsed from power-on. The timechart is shown in Table 4.1. After power-on, self-calibration is performed about every 30 minutes. Table 4.1 Self-calibration execution timechart Time elapsed Time elapsed (accumulated) 1 At power-on Initial calibration 2 About 30 minutes About 30 minutes 3 About 30 minutes About 60 minutes 4 About 30 minutes About 90 minutes 5 About 30 minutes About 120 minutes 6 About 30 minutes About 150 minutes 7 . . Every about 30 minutes . 9 4.5.3 Command processing during self-calibration If the disk drive receives a command execution request from the host while executing selfcalibration according to the timechart, the disk drive terminates self-calibration and starts executing the command precedingly. In other words, if a disk read or write service is necessary, the disk drive positions the head to the track requested by the host, reads or writes data, and restarts calibration. This enables the host to execute the command without waiting for a long time, even when the disk drive is performing self-calibration. The command execution wait time is about maximum 100 ms. 4 - 10 C141-E069-02EN
![](/manual_guide/products/fujitsu-mpd3173at-product-manual-0e5bce5/55.png)