HP 400N HP JetDirect 400N Print Server Hardware Installation Guide - 5969-3587 - Page 45
Task 4. Verify the card was installed correctly, For HP 2500C/CM Professional Series
UPC - 088698733714
View all HP 400N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Task 4. Verify the card was installed correctly 1. Print a new self-test page or configuration page. 2. Using the diagram on the following page as a guide, locate the phrase "I/O CARD READY" on the self-test page. The I/O CARD READY message is included in the MIO section of the self-test page, which also provides information about the following: • Product number • Firmware revision number • LAN hardware address • Port selection type • Manufacturing identification number • Network statistics • Network protocol messages NOTE For HP 2500C/CM Professional Series and HP DesignJet ColorPro GA printers, the MIO information is provided on a separate HP JetDirect self-test page, which prints immediately after the printer's diagnostic page. 2 Installation Installing the HP JetDirect Print Server Card 2-31