HP 400N HP JetDirect 400N Print Server Hardware Installation Guide - 5969-3587 - Page 52
Configuring Novell NetWare Frame Types, Novell NetWare Frame Types, on an HP JetDirect Ethernet Card
UPC - 088698733714
View all HP 400N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
8. Press [Item] to continue to the next protocol. Example: To enable the DLC/LLC protocol, press [Item] until the control panel displays either DLC/LLC=ON* or DLC/LLC=OFF*. If DLC/LLC=ON* is displayed, press [Item] to retain that protocol and continue to the next protocol. This turns on the DLC/LLC protocol. If DLC/LLC=OFF* is displayed, press [+] and then press [Select] or [Enter] to change the protocol. Then press [Item] again to continue to the next protocol. 9. To activate the printer and save your changes, press [On Line] (for LaserJet 5 Series printers, press [Go]). To complete the print server configuration, see the HP JetDirect software installation guide included with the product. Configuring Novell NetWare Frame Types If the NetWare protocol is enabled (IPX/SPX=ON*), you can set the NetWare frame type from the control panel. You can configure one of the following frame type settings: Novell NetWare Frame Types on an HP JetDirect Ethernet Card Frame Type AUTO (default) EN_8023 EN_II EN_8022 EN_SNAP Description Automatically senses and limits the frame type to the one detected. Limits the frame type to IPX over IEEE 802.3 frames. All others will be counted and discarded. Limits the frame type to IPX over Ethernet frames. All others will be counted and discarded. Limits the frame type to IPX over IEEE 802.2 with IEEE 802.3 frames. All others will be counted and discarded. Limits the frame type to IPX over SNAP with IEEE 802.3 frames. All others will be counted and discarded. 3-4 Using the Control Panel for Printers