HP LH4r HP Netserver LP 2000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 102
DiagTools, Setup (BIOS) Utility, HP TopTools Remote Control Card - This is an accessory PCI board
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Chapter 10 Configuring the HP Netserver • HP TopTools Remote Control Card - This is an accessory PCI board that provides a connection for remote LAN or modem-based server management software (HP TopTools) when installed into the Netserver. • Integrated Remote Assistant - This is an embedded product called HP Integrated Remote Assistant (also referred to as Integrated RA). Integrated RA combines intelligent hardware and software to provide administrators with instant notification of Netserver operations and events. • Alert-On-LAN 2 (AOL2) and Wake-On-LAN (WOL) - These options allow simple remote server power management through the Embedded LAN A port. This feature allows the administrator to remotely power off, on, reset or power cycle the Netserver. To use the AOL2 and WOL options, each one must be enabled in the Netserver's (BIOS) Setup Utility under Embedded LAN Controllers in the LAN A submenu (Configuration > Embedded LAN Controllers > LAN A). You must also install the Netserver Agent software from the HP Netserver Navigator CD-ROM, and the AOL2 client software. Refer to the Netserver Alert-On-LAN 2 User Guide available online on the HP Netserver Online Documentation CD-ROM included with your system. DiagTools This utility provides an easy-to-use hardware diagnostic for Netserver verification, burn-in, and rapid troubleshooting. It must first be copied to diskettes and then executed from the diskettes. NOTE HP recommends using the HP DiagTools utility to verify all Netserver functions are operating correctly, after completing all the configuration topics. The HP DiagTools utility also generates a text file containing the hardware detected and the DiagTools test results. This text file, called a support ticket, should be saved to a diskette and used for future reference, especially by your support provider. Setup (BIOS) Utility The HP Netserver (BIOS) Setup Utility is used to configure the following Netserver options: • User Preferences • Security • Configuration • Exit 96