HP LH4r HP Netserver LP 2000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 85
Marking the Columns, Right, Front of, Mark this face of, the columns with, masking tape
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Chapter 8 Rack Mounting the HP Netserver (2-Post) Marking the Columns To make it easier to mount the HP Netserver in the rack, you may want to mark the column holes that will be used by the Netserver. The Netserver may be mounted using either flush-mount or center-mount brackets that attach to the front side of the two columns. Use a marking pen or masking tape to mark the columns. Use the HP Rack Configuration Tools to determine where in the rack to mount the HP Netserver. The tools are available at: http://www.hp.com/netserver/support Use the marking pen or masking tape to mark the server position on the front of both columns. See Figure 8-2. The two brackets are mounted at the 1st and 5th holes on the columns, relative to the bottom of the HP Netserver. Left Side Right Side Fifth Hole From Bottom Second Hole From bottom Bottom of HP Netserver Front of Rack Mark this face of the columns with masking tape or marker pen. Figure 8-2. Location Marks on the Rack's Front Columns 79