HP LH4r HP Netserver LP 2000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 57
Refer to Opening and Closing the HP
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Chapter 6 Installing an Additional Processor CAUTION Take the following precautions when installing processors: • Leave the processor in the anti-static bag until you are ready to install it. • Wear an anti-static wrist strap and use a static-dissipating work surface or grounding mat connected to the chassis when handling components. • Before removing a processor from the anti-static bag, touch a grounded, unpainted metal surface to discharge static electricity. 1. Unpack the processor shipping box and check the contents against the packing list. CAUTION Do not unseal the anti-static bag, or remove the processor until you are ready to install it. 2. Log off all users, backup files, and shut down the NOS according to the instructions in your NOS documentation. 3. Press the power switch on the HP Netserver control panel when prompted by the operating system. Normally, this completes the shutdown procedure. WARNING Power supplies continue to provide standby current to the Netserver until the power cables are disconnected. 4. Disconnect the AC power cord. 5. Gain access to the system board: a. Pull out the anti-tip foot at the bottom of the rack. Then slowly slide the HP Netserver chassis out from the rack as far as it can be extended. b. Remove the cover. Refer to Chapter 2, "Opening and Closing the HP Netserver." c. Remove rear blower. Refer to Chapter 1, "Opening and Closing the HP Netserver." d. Remove the air flow guide. Refer to Chapter 2, "Opening and Closing the HP Netserver." 51