HP LH4r HP Netserver LP 2000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 45
Installing Additional Boards, Introduction, Tested PCI Boards, Tools Required
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
5 Installing Additional Boards Introduction The HP Netserver LP 2000r provides three 64-bit PCI slots connected to a riser board contained in the PCI card cage. The slots will accept full-length 32-bit or 64-bit PCI accessory boards. Tested PCI Boards For a list of tested PCI boards, check for compatibility in Configuration Assistant on the Navigator CD-ROM or look for the Hardware Tested Products list for the HP Netserver LP 2000r under the Service and Support topic for the specific NOS used in the Netserver at HP's web site: http://www.hp.com/netserver/support/ All Hewlett-Packard accessory boards comply with the U.S. National Electrical code (NFPA 70) Class 2. For additional information, refer to the Readme file and Configuration Advisor on your HP Netserver Navigator CD-ROM. Refer to Chapter 10, "Configuring the HP Netserver," for instructions. CAUTION Some accessory board outputs may exceed U.S. National Electrical code (NFPA 70) Class 2 or limited power source limits and must use appropriate interconnecting cabling in accordance with the National Electrical Code. Tools Required You will need the following tools to add or remove accessory boards: • ¼-inch Phillips screwdriver (for removing the slot cover) • An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit includes a static-dissipating work surface, a chassis clip lead, and a wrist strap. 39