HP LH4r HP Netserver LP 2000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 86
Preparing the HP Netserver, Removing Existing Hardware
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Chapter 8 Rack Mounting the HP Netserver (2-Post) Preparing the HP Netserver Before the HP Netserver can be mounted in the rack, you need to remove the factory-installed chassis slides from the Netserver and install the flush-mount or center-mount brackets. 1. Lay the HP Netserver on a flat surface. 2. Remove the slides from the sides of the chassis. See Figure 8-3. Figure 8-3. Removing Existing Hardware 3. If you are center-mounting the HP Netserver, remove the center spacers (attached to the chassis under the slides). See Figure 8-3. 4. If you are flush-mounting the HP Netserver, remove front bezel and the front brackets. See Figure 8-3. Do not remove the front brackets if you are center-mounting the HP Netserver. In this case, the front brackets are needed to attach the bezel. 80