HP LH4r HP Netserver LP 2000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 71
Marking Rack Columns, HP Rack Configuration Tools
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Chapter 7 Rack Mounting the HP Netserver (4-Post) Marking Rack Columns To make it easier to install the slides in the rack, you may want to mark the rack columns to indicate the server placement. Use the HP Rack Configuration Tools to determine where in the rack to mount the HP Netserver. The tools are available at: http://www.hp.com/netserver/support Use a marking pen or masking tape to mark the server position on the face of the front columns and the inside of the rear columns. The example in Figure 7-2 shows a HP System /E or /U rack. Rear of Rack "#" represents the EIA unit numbers on the rack columns. Third Hole From Bottom First Hole From Bottom Masking Tape or Marker Left Side Mark this face of the columns with masking tape or marker pen. Right Side Bottom of HP Netserver Front of Rack Figure 7-2. Marking Rack Columns 65