HP LaserJet 4v/mv HP LaserJet 4V and 4MV Printer - User’s Guide, C314 - Page 133
Clearable Warnings
View all HP LaserJet 4v/mv manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
Clearable Warnings If you receive a clearable warning message, the printer changed settings (see Table 8-2 below) in order to print your print job. Table 8-2 Clearable Warning Messages Message W0 JOB 600/A4 W1 IMAGE ADAPT W2 INVALID PERS W3 JOB ABORTED WD DISK NOT INIT W8 JOB 600/OFF W9 JOB 600/LTR WM JOB 300 WM JOB 600/A3 WM JOB 600/LGL WM MEM CNFIG N/A WM CHK MEM CNFIG WM [personality] MEM FULL Meaning Because the job parameters of resolution and page protection could not be met with the available memory, the job was downgraded to a resolution of 600 dpi and page protect of A4. The printer received a graphics print file that was too complex to print at the requested resolution. Check the printout for loss of data or print quality. NOTE: if this warning occurs frequently, install additional memory. The job was not printed because you requested a personality, such as PostScript, that had not been installed. Install the personality that matches the personality of the files you are sending, together with enough memory to support that personality. The printer was forced to abort the print job because there was not enough installed memory to support the current printer language (PostScript, for example). Install additional memory. The printer was unable to read the root directory from the disk. Use the disk initalization utility to initialize the disk. Because the job parameters of resolution and page protection could not be met with the available memory, the job was downgraded to a resolution of 600 dpi and page protect off. Because the job parameters of resolution and page protection could not be met with the available memory, the job was downgraded to a resolution of 600 dpi and page protect of letter. The job was printed at 300 dpi. NOTE: if this warning occurs frequently, install additional memory. Because the job parameters of resolution and page protection could not be met with the available memory, the job was downgraded to a resolution of 600 dpi and page protect of A3. Because the job parameters of resolution and page protection could not be met with the available memory, the job was downgraded to a resolution of 600 dpi and page protect of legal. The printer did not have enough memory when switched on to support the previous settings for I/O Buffering and/or Resource Saving, probably because you removed a memory SIMM, or added a new personality SIMM. (You can check settings by printing a self test.) I/O Buffering and/or Resource Saving settings were altered when the printer was switched on because the printer did not have enough memory. This usually occurs after memory has been removed from the printer. (You can check settings by printing a self test.) Adding additional memory should correct this problem. The Resource Saving memory area for the specified personality is full. Press [Shift] + [Continue] to continue printing (some data will be lost). The current job will print, but some resources (downloaded fonts, etc.) may not be saved. If this error occurs frequently, you may need to adjust Resource Saving settings. A clearable warning appears if the printer detects a transient condition, such as an invalid or uninstalled personality, or lack of memory causes a temporary change in resolution. A number of clearable warnings can appear while printing a job. The printer will continue on line while the message is displayed. Clear the message by pressing [Shift] + [Continue]. For information about eliminating the need to respond to clearable warning messages, see under the "Configuration Menu" in Chapter 4. 8-28 Solving Printer Problems