HP LaserJet 4v/mv HP LaserJet 4V and 4MV Printer - User’s Guide, C314 - Page 152
Memory/Personality SIMM Installation D-3
View all HP LaserJet 4v/mv manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
5 20 6 45 7 8 5 Insert the board firmly into the SIMM slot at about a 20-degree angle. Use closest open slot toward the back of the printer. 6 Rotate the SIMM toward the back of the printer to about a 45-degree angle until it clicks into the metal locking tabs. If it is properly seated, it will not lift away from the slot. (To remove a SIMM, you must first release the metal locking tabs.) 7 Slide the printer controller board back into the printer (A) and tighten the two screws (B). 8 Reattach any cables (A) and the power cord (B), then switch the printer ON (C) and test the SIMM (see the following section). Memory/Personality SIMM Installation D-3
5
Insert the board
firmly
into the SIMM slot
at about a 20-degree angle. Use closest
open slot toward the back of the printer.
6
Rotate the SIMM toward the back of the
printer to about a 45-degree angle until it
clicks into the metal locking tabs. If it is
properly seated, it will not lift away from
the slot. (To remove a SIMM, you must
first release the metal locking tabs.)
7
Slide the printer controller board back
into the printer (
A
) and tighten the two
screws (
B
).
8
Reattach any cables
(
A
) and the power
cord (
B
)
,
then
switch the printer ON
(
C
)
and test the SIMM (see the following
section).
5
20
45
6
7
8
Memory/Personality SIMM Installation D-3