HP M1522nf HP LaserJet M1522 MFP - Software Technical Reference - Page 234

The name that appears in the Name text box depends on the following conditions: ● If a saved custom paper size has been selected from the drop-down menu on the Paper/Quality tab, then the Name text box shows the name of the selected custom paper size. ● If a standard paper size has been selected on the Paper/Quality tab, then the Name text box shows the default name of "Custom." ● If a new name has been typed into the Name text box for the purpose of saving a new size or renaming an existing size, then that new name will remain in the text box until the new size is saved or the dialog box is closed. If you type a new name into the Name text box, but do not click Save, you can change the width and height values without losing the name. However, if you close the dialog box without clicking Save, any unsaved name or size values are lost without warning. Custom paper sizes Change the width and height values by typing numeric strings into the Width and Height fields in the Custom Paper Size dialog box. Any entry that is greater than the maximum limits of the width and height controls is rounded down to the maximum valid entry, while any entry that is smaller than the minimum limits of the width and height control is rounded up to the minimum valid entry. If units are in millimeters, the custom paper-size range minimum is the limit rounded up to the nearest whole millimeter. The custom paper-size range maximum is the limit rounded down to the nearest whole millimeter. Any non-numerical entry reverts to the last valid entry. Width and height entries are validated when the focus has changed. The resolution of each control is 1 millimeter or 1/10 of an inch, depending on the current measurement units. Units To change measurement units, click one of the options in the Units group box, either Inches or Millimeters. Custom width and height control limits The minimum paper size for the product is 76.2 x 127 mm (3 x 5 inches) and the maximum size is 215.9 x 355.6 mm (8.5 x 14 inches). The following table summarizes paper size limits for each paper-handling option. Table 4-1 HP PCL6 printer driver custom paper sizes Tray Dimensions Minimum Maximum Priority input tray Width 76 mm (3.0 inches) 215 mm (8.5 inches) Height 127 mm (5.0 inches) 356 mm (14.0 inches) Tray 1 Width 148.0 mm (5.83 inches) 215 mm (8.5 inches) Height 210 mm (8.26 inches) 356 mm (14.0 inches) Duplexing unit Width 148.0 mm (5.83 inches) 215 mm (8.5 inches) Height 210.0 mm (8.26 inches) 356 mm (14.0 inches) 212 Chapter 4 HP PCL 6 and HP postscript level 3 emulation printer drivers, and HP PCL 5 UPD for ENWW Windows