HP Pro 3330 HP Pro 3330 Microtower PC, HP Pro 3330 Small Form Factor PC, and H - Page 76
Removing a Hard Drive, - mt drivers
View all HP Pro 3330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Figure 7-22 Optical drive alignment hole Removing a Hard Drive NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive. Also, if you are replacing the primary hard drive, make sure you have created a Recovery Disc Set to restore the operating system, software drivers, and any software applications that were preinstalled on the computer. 1. Prepare the computer for disassembly (Preparation for Disassembly on page 42). 2. Remove the access panel (Access Panel on page 43). 66 Chapter 7 Removal and Replacement Procedures - Microtower (MT) Chassis
Figure 7-22
Optical drive alignment hole
Removing a Hard Drive
NOTE:
Before you remove the old hard drive, be sure to back up the data from the old hard drive so
that you can transfer the data to the new hard drive. Also, if you are replacing the primary hard drive,
make sure you have created a Recovery Disc Set to restore the operating system, software drivers,
and any software applications that were preinstalled on the computer.
1.
Prepare the computer for disassembly (
Preparation for Disassembly
on page
42
).
2.
Remove the access panel (
Access Panel
on page
43
).
66
Chapter 7
Removal and Replacement Procedures – Microtower (MT) Chassis