HP Pro 3330 HP Pro 3330 Microtower PC, HP Pro 3330 Small Form Factor PC, and H - Page 88
Removing the fan
View all HP Pro 3330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
5. Disconnect the cable from the red/brown system board connector labeled SYS_FAN (1), pull the fan into the chassis until it clears the chassis lip, and then lift it out of the chassis (2). NOTE: System board appearance may vary. Figure 7-36 Removing the fan To install the fan, reverse the removal procedures. 78 Chapter 7 Removal and Replacement Procedures - Microtower (MT) Chassis
5.
Disconnect the cable from the red/brown system board connector labeled SYS_FAN
(1)
, pull the
fan into the chassis until it clears the chassis lip, and then lift it out of the chassis
(2)
.
NOTE:
System board appearance may vary.
Figure 7-36
Removing the fan
To install the fan, reverse the removal procedures.
78
Chapter 7
Removal and Replacement Procedures – Microtower (MT) Chassis