HP ProLiant DL185 HP ProLiant DL185 Generation 5 Server Software Configuration - Page 36
Re-initialize onboard I/O ports, System BIOS configuration 36
View all HP ProLiant DL185 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Table 22 Beep codes and checkpoint codes Code 84h 85h 86h 87h 88h 89h 8Ah 8Bh 8Ch 8Eh 8Fh 90h 91h 92h 93h 95h 96h 97h 98h 99h 9Ah 9Bh 9Ch 9Dh 9Eh 9Fh A0h A2h A4h A8h AAh ACh Beep code 1-2 Description Detect and install external parallel ports Initialize PCI devices Re-initialize onboard I/O ports Configure system board configurable devices (optional) Initialize BIOS data area Enable non-maskable interrupts Initialize extended BIOS data area Test and initialize PS/2 mouse Initialize floppy controller Autotype hard drive size Determine number of ATA drives (optional) Initialize hard disk controllers Initialize local bus hard disk controllers Jump to user patch 2 Build MP table for multiprocessor boards Install CD-ROM for boot Clear huge ES segment register Fix up MP table Search for option ROMs. One long, two short beeps on checksum failure Check for SMART drive (optional) Shadow option ROMs Power management processor speed Set up power management Initialize security engine (optional) Enable hardware interrupts Determine number of SATA or SAS drives Set time of day Check key lock Initialize typematic rate Erase F10 prompt Scan for F10 key stroke Enter Setup System BIOS configuration 36