HP ProLiant DL185 HP ProLiant DL185 Generation 5 Server Software Configuration - Page 58
Server management, Pre- and post-installation procedures
View all HP ProLiant DL185 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Server management Pre- and post-installation procedures Pre-installation procedures WARNING: Failure to properly turn off the server before you open the server or before you start removing or installing hardware components may cause serious damage as well as bodily harm. WARNING: To reduce the risk of personal injury from hot surfaces, allow the chassis and any installed hardware components to cool before touching them. CAUTION: Follow the ESD precautions listed in Chapter 2 of the HP ProLiant DL185 Generation 5Server Maintenance and Service Guide when handling any hardware component. 1. Turn off the server and all the peripherals connected to it. 2. Disconnect the AC power cord from the power supply cable located on the server rear panel to turn off the service processor and reduce the risk of electrical shock. 3. Remove the top cover from the chassis: a. Loosen the captive screw on the rear panel. b. Slide the cover approximately 1.25 cm (0.5 in) toward the rear of the unit, then lift the cover away from the chassis. Figure 31 Removing the top cover 4. Place the top cover in a safe place for reinstallation later. Server management 58