HP Q6651C HP Designjet Z6100 Printer Series - User's Guide - Page 178

Troubleshoot paper Take-up reel LED status Issue Print job interrupted? Blinking slowly Solid red Take-up reel is not No winding Take-up reel is not No winding Solid green Solid green Take-up reel is not No winding Take-up reel is winding No in the wrong direction Possible cause Possible solution bin if you are using the HP Designjet Z6100 42-in Printer, or any objects. See the following graphic. Make sure that the collection bin is placed behind the foot brace. Also ensure that the take-up reel power switch is in the On position. The sensor cables are loose or unplugged. Ensure that the sensor cables are correctly secured. There is too much resistance on the takeup reel motor. Ensure that the paper is not winding too tightly. A loop-shaping core should be inserted and hanging as shown in step 10 of Use the takeup reel on page 38. The take-up reel power switch is in the Off position Ensure that the take-up reel power switch is in the On position. The take-up reel winddirection switch is in the wrong winding position. Flip the take-up reel wind-direction switch to the correct position. After 3 seconds, the printer recognizes the problem and interrupts the print job. See the first error listed in this table. The following graphic shows the take-up reel sensors and cable. 1. Take-up reel sensor 2. Take-up reel sensor and cable housing unit 166 Chapter 12 Troubleshoot paper issues