Hitachi P50X901 Owners Guide - Page 4
First time use - plasma
View all Hitachi P50X901 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
First time use Accessories Check to make sure you have the following accessories before disposing of the packing material. ³ Remote Control · Simple Remote ´ Power Cord ² 2 IR Blaster Cables CH + GUIDE VOL - SELECT VOL + MUTE CH - MENU EXIT FAV CH INPUTS POWER » Two "AA" size, 1.5V batteries ¶ Power Swivel Table Top Stand Optional Fixed Tabel Top Stand (P50X901 model only) (Part No. STF0760 P60X901 only) CH 3 ¿ Two "AAA" size, 1.5V batteries º Power Swivel Cable (P50X901 model only) ¾ Wire Clamp For U.S. models: For optional accessories, please access our web site at: www.hitachi.us/tv CANADA only: For optional accessories, please access our web site at: www.hitachi.ca/tv CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate ventilation for the electronics or proper support for the front glass panel. This plasma television product is designed for a maximum tilting angle of 45 degrees from vertical. 2. This stand for use only with Hitachi P50X901. Use with other apparatus is capable of resulting in instability causing possible injury. 3. The wall mount unit for the 50" model is WM07S and for the 60" model is WM07L. Please see page 7 for important information related to the wall mount. The Wall Mount unit is an optional accessory (Not Included). ³ Remote Control Unit CLU-4372A ´ Power Cord (Part No. EV01841). (Part No. HL02402). ² Two IR Blaster cables (Part No. EY01641). · Simple Remote Control Unit CLU-123S ¶ Power Swivel Table Top Stand (Part No. QJ03754 P50X901 only). (Part No. HL01864) CH 3 Optional Fixed Tabel Top Stand (Part No. STF0760 P60X901 only) » Two "AA" size, 1.5V batteries º Power Swivel Cable (Part No. EW08433 P50X901 only). ¿ Two "AAA" size, 1.5V batteries ¾ Wire clamp REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT 1. Open the battery cover of the remote control by pushing down and sliding the back cover off. 2. Insert two new "AA" and "AAA" size batteries for the remote control and Simple Remote Control. When replacing old batteries, push them towards the springs and lift them out. 3. Match the batteries to the (+) and (-) marks in the battery compartment. BOTTOM VIEW (Remote Control) BOTTOM VIEW (Simple Remote Control) 4. Insert the bottom of the battery, the (-) side, into the battery compartment first, push towards the springs and insert the top of the battery, the (+) side, into place. Do not force the battery into the battery compartment. 5. Replace the cover. Lift up on tab to remove back cover. Lift up on tab to remove back cover. Lift up on tab to remove back cover. CAUTION: Do not insert batteries with '+' and '-' polarities reversed as this may cause the batteries to swell or rupture resulting in leakage. 4