Husqvarna AUTOMOWER 415X Owner Manual - Page 14
Warning, Caution
![]() |
View all Husqvarna AUTOMOWER 415X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
• Put the charging station in an area with protection from the sun. • If the charging station is installed on an island, make sure to connect the guide wire to the island. Refer to To make an island on page 16. 3.4.3 To examine where to put the boundary wire CAUTION: There must be a barrier of minimum 15 cm / 6 in. in height between the boundary wire and water bodies, slopes, precipices or public roads. This will prevent damage to the product. CAUTION: Do not let the product operate on gravel. 3.4.2 To examine where to put the power supply WARNING: Do not cut or extend the low-voltage cable. There is a risk of electrical shock. CAUTION: Make sure that the blades on the product do not cut the low-voltage cable. WARNING: The power supply cable and extension cable must be outside the work area to avoid damage to the cables. CAUTION: Do not make sharp bends when you install the boundary wire. CAUTION: For careful operation without noise, isolate all obstacles such as trees, roots and stones. The boundary wire should be put as a loop around the work area. Sensors in the product senses when the product approaches the boundary wire, and the product selects another direction. All parts of the work area must be maximum 35 m / 115 ft. from the boundary wire. To make the connection easier between the guide wire and the boundary wire, it is recommended to make an eyelet where the guide wire will be connected. Make the eyelet with approximately 20 cm / 8 in. of the boundary wire. CAUTION: Do not put the low-voltage cable in a coil or below the charging station plate. The coil causes interference with the signal from the charging station. • Put the power supply in an area with a roof and protection from the sun and rain. • Put the power supply in an area with good airflow. • Use a residual-current device (RCD) with a tripping current of maximum 30 mA when you connect the power supply to the power outlet. Low-voltage cables of different lengths are available as accessories. Note: Make a blueprint of the work area before you install the boundary wire and guide wire. 14 - Installation 1650 - 005 - 17.03.2022
![](/manual_guide/products/husqvarna-automower-415x-selfinstall-owner-manual-35fd2bb/14.png)