Husqvarna AUTOMOWER 415X Owner Manual - Page 16
Caution
View all Husqvarna AUTOMOWER 415X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
the slope. You can use a wall or a fence as a barrier. 3.4.3.2 Passages A passage is a section that has boundary wire on each side and that connects 2 parts of the work area. The distance between the boundary wire on each side in the passage must be a minimum of 60 cm / 24 in. Note: If a passage is less than 2 m / 6.5 ft. wide, install a guide wire through the passage. This will prevent damage to the blades of the product. The recommended minimum distance between the guide wire and the boundary wire is 30 cm / 12 in. The product always runs to the left of the guide wire as seen facing the charging station. It is recommended to have as much free area as possible to the left of the guide wire (A). >60 cm / 24" A >30 cm / 12" To make an island, isolate areas in the work area with the boundary wire. We recommend to isolate all stable objects in the work area. Some obstacles are resistant to a collision, for example, trees or bushes that are more than 15 cm / 6 in. in height. The product will collide with the obstacle and then select a new direction. • Put the boundary wire to and around the obstacle to make an island. • Put the 2 sections of boundary wire to and from the island close together. This will make the product run across the wire. • Put the 2 sections of boundary wire in the same stake. >2 m / 6.5 ft 3.4.3.3 To make an island CAUTION: Do not put a section of boundary wire across the other. The sections of boundary wire must be parallel. 0 cm / 0" CAUTION: Do not put the guide wire across the boundary wire. CAUTION: Isolate or remove obstacles that are less than 15 cm / 6 in. in height. Isolate or remove obstacles that slope slightly, for example, stones, trees or roots. 3.4.3.4 To make a secondary area Make a secondary area (B) if the work area has 2 areas that are not connected with a passage. The work area with the charging station is the main area (A). Note: The product must be manually moved between the main area and the secondary area. 16 - Installation 1650 - 005 - 17.03.2022