IBM QS21 Service Guide - Page 59
Removing, blade-server, front, bezel, assembly, Replacing, system, board, planar
![]() |
UPC - 883436016940
View all IBM QS21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Removing the blade-server front bezel assembly Before you can replace a defective system board assembly or blade server front bezel assembly, you must first remove the blade server front bezel assembly. Figure 20 shows how to remove the front bezel assembly from a blade server. Blade Cover Blade-Cover Release Bezel-Assembly Release Blade-Cover Release Bezel-Assembly Release Control-Panel Cable Control-Panel Connector Bezel Figure 20. Removing the front bezel assembly Complete the following steps to remove the front bezel assembly: 1. Read the safety information beginning on page vii and "Installation guidelines" on page 29. 2. Open the blade server cover. 3. Carefully disconnect the control panel cable from the control panel connector. 4. Press the front bezel release on both sides of the system board and pull the front bezel assembly away from the blade server. 5. Store the front bezel assembly in a safe place. Replacing the system board base and planar Figure 21. System board assembly Chapter 4. Installing and removing replaceable units 41
![](/manual_guide/products/ibm-qs21-service-guide-e5564bd/59.png)