Icom IC-7410 Instruction Manual - Page 104
Dial tuning tension adjustment - cpu reset
View all Icom IC-7410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
13 MAINTENANCE ■ Troubleshooting (continued) D Scanning PROBLEM POSSIBLE CAUSE SOLUTION REF. A programmed scan does not • Squelch is open. stop. • Set the [RF/SQL] control to the threshold p. 32 point. A programmed scan does not • The same frequencies are programmed into the • Program different frequencies into the Scan p. 70 start. Scan Edge Memory channels "P1" and "P2." Edge Memory channels "P1" and "P2." A memory scan does not start. • Two or more memory channels have not been • Program more than two memory channels. programmed. p. 70 A select memory scan does • Two or more memory channels have not been • Designate more than two memory channels as p. 80 not start. designated as select channels. select channels for the scan. A ∂F scan does not start. • T he center frequency for the ∂F scan is not • Program the center frequency for the ∂F scan. p. 81 programmed. D Display PROBLEM POSSIBLE CAUSE The displayed frequency does • The Dial Lock function is turned ON. not change properly. • The Set mode screen is selected. • The internal CPU has malfunctioned. SOLUTION • P ush [LOCK] to turn OFF the function. • P ush [MENU] to exit the Set Mode. • Reset the CPU. REF. p. 61 p. 85 p. 100 ■ Dial tuning tension adjustment The tuning tension of [DIAL] may be adjusted to suit your preference. The tension adjustment is located on the bottom side of the front panel. See the figure to the right. Slide the tension adjustment to a comfortable level while turning the dial continuously and evenly in one direction. DIAL Tuning tension adjustment Firm Light 97