Icom IC-7410 Instruction Manual - Page 93

SET MODE 10 7. User Band Edge 12. Quick SPLIT (Default: ON) This "User Band Edge" item appears only when "ON (User)" or "User (ON) & TX" is selected in the "Band Edge Beep" item. (p. 85) When you select "ON (User)" or "ON (User) & TX" in the "Band Edge Beep" item, you can program a total of 30 band edge frequencies in this item. See page 30 for programming details. Turn the Quick Split function ON or OFF. When this item is set to ON, hold down [SPLIT] for 1 second to shift the transmit frequency from the receive frequency, according to the "FM SPLIT Offset HF" or "FM SPLIT Offset 50" setting as described below. See page 67 for details. 13. FM SPLIT Offset HF (Default: -0.100MHz) 8. Beep Sound (Default: 1000Hz) Set the offset* to use the Quick Split function in the 1 Set a desired beep frequency for key operation to be- HF bands. tween 500 Hz and 2000 Hz in 10 Hz steps. *The difference between transmit and receive frequencies. 2 You can set the beep output level in the "Beep Level" item. (p. 85) The frequency offset can be set to between -9.999 MHz and +9.999 MHz in 1 kHz steps. 3 9. RF/SQL Control (Default: RF+SQL) 14. FM SPLIT Offset 50 (Default: -0.500MHz) 4 Set the [RF/SQL] control function. Set the offset* to use the Quick Split function in the 50 MHz 5 bands. • AUTO : [RF/SQL] functions as only an RF *The difference between transmit and receive frequencies. 6 gain control in SSB, CW and RTTY; a The frequency offset can be set to between -9.999 squelch control in AM and FM. MHz and +9.999 MHz in 1 kHz steps. 7 • SQL : [RF/SQL] functions as a squelch con- trol. • RF+SQL : [RF/SQL] functions as an RF gain con- 15. SPLIT LOCK (Default: OFF) 8 trol as well as a noise squelch or an S-meter squelch in FM; as an RF gain Turn the Split Lock function ON or OFF. 9 control as well as an S-meter squelch in SSB, CW, RTTY and AM. When this item is set to ON, you can use [DIAL] to adjust the transmit frequency while holding down [XFC], 10 even while the Dial Lock function is ON. 10. Meter Peak Hold (Default: ON) See pages 66, 67 for split frequency operation de- 11 Turn the Meter Peak Hold function ON or OFF. tails. 12 When this function is set to ON, the peak level of a received signal strength or the output power is displayed 16. Tuner (Auto Start) (Default: OFF) 13 for approximately 0.5 seconds. Turn the Automatic Antenna Tuner function ON or OFF. This function is for only the HF bands. 14 11. TOT (CI-V) (Default: OFF) To prevent a prolonged transmission, the transceiver • OFF : The internal antenna tuner remains OFF even when the SWR is high. 15 has a Time-Out Timer function. If a continuous transmission exceeds the set period, • ON : The internal antenna tuner automatically starts tuning when the SWR is high, even if the tuner 16 the transmission will be cut off. is turned OFF. 17 Set the time period to 3, 5, 10, 20 or 30 minutes, or turn OFF the function. 18 NOTE: This function will be activated only when you transmit using CI-V commands, or pushing [TRANS- 19 MIT] on the transceiver. 20 21 86