Icom IC-7410 Instruction Manual - Page 26
Power supply connections, Connecting to a DC power supply - diagram
View all Icom IC-7410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
2 INSTALLATION AND CONNECTIONS ■ Power supply connections When operating the transceiver with AC power, use a power supply with 13.8 V DC output and a capacity of at least 23 Amps. Refer to the diagrams below. CAUTION: Before connecting the DC power cable, check the following important items. Make sure: • The [POWER] switch is OFF. • Output voltage of the power source is 12-15 V when you use a non-Icom power supply. • DC power cable polarity is correct. Red : Positive + terminal Black : Negative _ terminal ■ Connecting to a DC power supply D Connecting to the PS-126 DC POWER SUPPLY AC outlet PS-126 To disconnect q w To [DC 13.8V] AC cable DC power cable Ground Transceiver D Connecting to a non-Icom DC POWER SUPPLY Transceiver For European versions Transceiver AC outlet Ground A DC power supply 13.8 V; at least 23 A +_ To [DC 13.8V] To disconnect q w To [GND] AC cable Red Black Supplied DC power cable To [DC 13.8V] Connect to power supply 19