Icom IC-M510 Instruction Manual - Page 21
PREPARATIONS, Entering the MMSI code
View all Icom IC-M510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
3 PREPARATIONS For only the European version: When you turn ON the transceiver, "Model" screen is displayed depending on the setting. Select the country where you operate the transceiver. 1 LL If no country is selected, "General" is automatically selected. 2 ■■ Entering the MMSI code 3 The Maritime Mobile Service Identity (MMSI: DSC self ID) code consists of 9 digits. You can only enter the code when turning ON the transceiver for the first time. 4 This initial code can be entered only once. After entering, it can be changed only by your dealer or distributor. 5 If your MMSI code has already been entered, doing the steps below is not necessary. 6 1. Hold down [PWR] to turn ON the transceiver. ••Three short beeps sound, and "Push [ENT] to Register 7 your MMSI" is displayed. 2. Push [ENT] to start entering the MMSI code. 8 ••The "MMSI INPUT" screen is displayed. LL Push [CLEAR] twice to skip the entry. If you skip the 9 entry, you cannot make a DSC call. To enter the code after skipping, turn OFF the power, and then turn it 10 ON again. 3. Enter the MMSI code. 11 TIP: 12 ••Select a number using [◄] and [►]. ••Push [ENT] or [CH/ENT] to enter the selected 13 number. ••Select "←" or "→" on the screen, or rotate 14 [CH/ENT] to move the cursor. 15 4. Repeat step 3 to enter all 9 digits. 5. Select Next and push [ENT] or [CH/ENT] to set the 16 entered code. ••The "MMSI Confirmation" screen is displayed. 17 6. Enter your MMSI code again to confirm. 18 7. Push Finish to set the entered code. ••When your MMSI code is successfully entered, "MMSI registered successfully." is briefly displayed, and then enters the operating screen. LL Your MMSI code is also displayed on the opening screen. 8