Icom IC-M510 Instruction Manual - Page 53
Receiving a Position Request call, When a Position Request call is received
View all Icom IC-M510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
7 DIGITAL SELECTIVE CALLING (DSC) D Receiving a Position Request call (May not be used, depending on the presetting) NOTE: Even if the Auto ACK function is set to "Manual," after receiving a Distress 1 Acknowledgment, or while in the Distress Cancel call procedure, the Position Reply is automatically sent to the calling station. 2 When a Position Request call is received: 3 • An alarm sounds. • "Received POS Request" is displayed. 4 1. Push Alarm OFF to turn OFF the alarm. 5 6 7 2. Push the Software Key below the intended operation. 8 Ignore : Ignores the call and returns to the operating screen. 9 • The call is saved in the DSC Log. • " " blinks continuously until you display 10 the call message. Hold : Holds the RX call task, and returns to the 11 Main screen. Able : Sends Acknowledgment "Able to comply" 12 (Able to right away. comply) 13 Unable: Sends an Acknowledgment "Unable to (Unable to Comply." 14 Comply) • The call is saved in the DSC Log. • Displays the Acknowledgment 15 information, and then returns to the operating screen by pushing STBY , and 16 then OK . 17 Accept : Accepts the call. • Displays the received call's information. 18 • The call is saved in the DSC Log. Push ACK Able or ACK Unable , then push Call to send the Position Reply call. (p. 32) 40