Intel SHG2 Product Guide - Page 32
Installing the Processor Wind Tunnel, Attaching the Heat Sink and Retention Clip
UPC - 735858152891
View all Intel SHG2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
7. Position the retention clip over the plastic tab and engage the retention clip end-slot over the plastic tab (see 1 in Figure 14). Note that the slot in the clip provides room for side-to-side motion while engaging the retention clip slots located at each end. 8. Press downward on the retention clip ends over the plastic tabs on the retention bracket (see 2 in Figure 14). 9. Install two retention clips for each processor you install. 2 1 2 OM14368 Figure 14. Attaching the Heat Sink and Retention Clip Installing the Processor Wind Tunnel The following instructions apply to the Intel SC5200 Base Server Chassis and reference chassis installations. If you are installing your server board in the Intel SC5200 Hot-Swap, Redundant Power Server Chassis, DO NOT install the processor wind tunnel. The ducting in the Intel SC5200 Hot-Swap, Redundant Power Server Chassis eliminates the need for a processor wind tunnel. Air flow for the processor wind tunnel should be directed toward the rear of the chassis as shown below. OM14375 Figure 15. Processor Wind Tunnel Air Flow 32 Intel Server Board SHG2 Product Guide