Intel SR1625UR Service Guide - Page 118
Restoring the BIOS Defaults
View all Intel SR1625UR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Restoring the BIOS Defaults If you need to restore the BIOS default settings, the BIOS Default jumper will need to be used. 1. Power down the system; do not disconnect the AC power. 2. Open the server system. For instructions on removing the system cover, see "Removing the Server System Cover" on page 41. 3. Locate the BIOS Default jumper block at board position J1E7. 4. Move the jumper from the normal operation position (covering pins 1 and 2) to the Set Default position (covering pins 2 and 3). . BIOS Default J1E7 Normal 2 Set 3 Default AF003113 Figure 86. BIOS Default Jumper 5. Wait five seconds. 6. Return the BIOS Default jumper to the normal position (covering pins 1 and 2). 7. Close the server system. 8. Power up the system. The BIOS defaults settings are now restored and can be reset by going into the BIOS setup. 100 Intel® Server System SR1625UR Service Guide