Intel SR1625UR Service Guide - Page 83
Removing the I/O Expansion Module(s), Installing the PCI Riser Assembly
![]() |
View all Intel SR1625UR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
I/2O-SEoxcpk.eMt odule I/1O-SEoxcpk.eMt odule A Snap Standoff C B Standoff Hole Server Board I/O Connector 1 Filler Panels AF002855 Figure 51. Installing the I/O Expansion Module to the Server System 7. Install the processor air duct. For instructions, see "Installing the Processor Air Duct" on page 49. 8. Install the PCI riser assembly into the server system. For instructions, see "Installing the PCI Riser Assembly" on page 44. Removing the I/O Expansion Module(s) To remove the I/O expansion module, follow these steps: 1. Remove the PCI riser assembly. For instructions, see "Removing the PCI Riser Assembly" on page 43. 2. Remove the processor air duct. For instructions, see "Removing the Processor Air Duct" on page 48. 3. Disconnect the I/O expansion module from the server board connector and the standoffs and remove the module out of the server system (see letter "A" in Figure 52). 4. Remove the standoffs from the server board (see letter "B" in Figure 52). Intel® Server System SR1625UR Service Guide 65
![](/manual_guide/products/intel-sr1625ur-service-guide-02b4d1e/83.png)