Intel SR1625UR Service Guide - Page 88
Removing and Installing the Midplane Board, Removing the Midplane Board
View all Intel SR1625UR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
5. Install the Intel® RMM3 filler panel into the system back panel (see Figure 58). AF002998 Figure 58. Installing the Intel® RMM3 filler panel 6. Install the processor air duct. For instructions, see "Installing the Processor Air Duct" on page 49. 7. Install the PCI riser assembly into the server system. For instructions, see "Installing the PCI Riser Assembly" on page 44. Removing and Installing the Midplane Board The following sections describe how to replace the midplane board. Removing the Midplane Board To remove the midplane board, follow these steps: 1. Remove the PCI riser assembly. For instructions, see "Removing the PCI Riser Assembly" on page 43. 2. Remove the processor air duct. For instructions, see "Removing the Processor Air Duct" on page 48. 3. Disconnect all cables from the midplane board. 4. Remove the bridge board as follows: a. Open the bridge board connector retention clips on the midplane and server board. b. Disconnect the bridge board from the connector on the midplane and server board and lift the bridge board straight up. 70 Intel® Server System SR1625UR Service Guide