Intel SR1625UR Service Guide - Page 89
Installing the Midplane Board, Replacing the, Power Distribution Module
![]() |
View all Intel SR1625UR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
5. Remove the power distribution board cover. For instructions, see "Replacing the Power Distribution Module" on page 84. 6. Unscrew the thumbscrew (see letter "A" in Figure 59). 7. Hold the midplane board only by the edges and slide the midplane board in the direction shown to release it from the backplane (see letter "B" in Figure 59). 8. Lift the midplane board over the retention pins (see letter "C" in Figure 59) and out of the server system (see letter "D" in Figure 59). C B D A Figure 59. Removing the Midplane from the Server System AF002859 Installing the Midplane Board To install the midplane board, follow these steps: 1. Lower the midplane board into the system and position the midplane board over the retention pins (see letter "A" in Figure 60) . 2. Align the four holes on the midplane with the four standoffs on the chassis and press down uniformly until it clicks into place (see letter "B" in Figure 60). 3. Slide the midplane board in the direction shown (see letter "C" in Figure 60) and insert the midplane into the backplane connector. 4. Tighten the thumbscrew (see letter "D" in Figure 60). Intel® Server System SR1625UR Service Guide 71
![](/manual_guide/products/intel-sr1625ur-service-guide-02b4d1e/89.png)