JVC DLA-RS45U 288 page operation manual for D-ILA Projectors DLA-RS65, DLA-RS5 - Page 72
] Function
View all JVC DLA-RS45U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
3 Operation Adjustments and settings in the menu (continued) [5] Function Use this function to set command communications, remote control codes, OFF timer function, etc. You can also reset the lamp time. Use the UP/DOWN keys to select an adjustment item. Press the [BACK] key to return to the previous screen. Trigger Off Timer High Altitude Mode Remote Code Network Remote Code Lamp Reset Off Off Off RS-232C A Items Trigger Off On (Power) On (Anamo) Off Timer Off 1 Hour 2 Hours 3 Hours 4 Hours High Altitude Mode On Off Communication Terminal RS-232C LAN Network Remote Code A B Lamp Reset Explanation, operation, precautions, settings Configures 12V output to an external screen equipped with a trigger function. Settings: Off, On(Power), On(Anamo) [Off] No output. When turned on, control signals (12V) from the trigger terminal are emitted. If you turn off the power, the output of the control signal stops. During standby mode, an output will occur if the [OK] button is pressed. After cooling, the output stops when you go back to standby. Control signals (12V) are emitted when the Anamorphic mode is set from "Off" to "A" or "B". If the Anamorphic mode is set to "A" or "B", the operation in this state equals "On (Power)". Sets Off Timer function and its time. (*) If there are no operations, the unit powers off automatically. (*) It powers off automatically even while projecting an image. (*) You will be given a warning 60 seconds before power turns OFF. Press the [OK] button while the warning is being displayed to delete the warning display. You cannot configure settings to omit warning display. Settings: Off, 1 hour, 2 hours, 3 hours, 4 hours [Off] Power is not turned off. Power is turned off automatically after 1 hour. Power is turned off automatically after 2 hours. Power is turned off automatically after 3 hours. Power is turned off automatically after 4 hours. Set to use at low pressure locations (900m above sea level). Settings: On, Off [Off] Set. Do not set. Sets the used control terminal. It is not possible to use it at the same time. Settings: RS-232C, LAN [RS-232C] Sets the RS-232C terminal. Sets the LAN terminal. It is displayed, if the setting of the "Communication terminal" to the submenu "[5-1] Network" is set to "LAN". Use this function to change the projector's remote control code. The projector can be operated only with a remote control configured with the same code. To change the remote control code itself, press "MENU" and [BACK] together for three seconds or more. All of the buttons on the remote control will begin to blink. Two blinks indicate "Change A to B"; three blinks indicate "Change B to A". Settings: A, B [A] Set the projector's remote control code to "A". Set the projector's remote control code to "B". Reset of the lamp use time to "0". 72