Lantronix G520 G520 User Guide - Page 117

10: Services Parameters GPS Parameters Sending Data Description Select to enable individual GPS settings.  Time  Latitude  Longitude  Altitude Table 10-24 Reporting Agent Data Send Configuration Parameters Device Info Reporting Agents Description Select to allow reporting agent to retrieve device IMEI information. Select the reporting agent. Generic agent is the default selection. Enable Data Send Select to enable data send. Protocol Select the protocol used in the data transmission. Options are TCP, UDP, HTTP, or HTTPS. Depending on the protocol that you selected, the server fields will vary. Starting string of the frame When TCP is selected, a start of frame sequence can be used to indicate the first frame of the data sent by the reporting agent. This string must be less than 20 characters in length. Ending string of the frame When TCP is selected, a start of frame sequence can be used to indicate the first frame of the data sent by the reporting agent. This string must be less than 20 characters in length. IP1/URL1 Enter the IP address or the URL of the destination server. Port1 Enter the port number (for TCP and UDP). TCP Timeout Enter the timeout in seconds to switch between primary and backup IP in case of connectivity failure. TCP user timeout value should be between 10 and 900 seconds. Backup This option is available when TCP protocol is selected. Select Backup check box to configure the backup TCP server.  IP2/URL2  Port2 The backup IP will be used after 3 failed attempts to send data to primary server. Reporting agent will continue to send data to backup server until the backup server fails or the device reboots. Send Interval in Second The period of time between two data transmissions. Data Format Figure 10-1 shows a portion of the reporting agent data format for a case where all settings were selected. G520 Series IoT Cellular Gateway User Guide 117