Lantronix SLC 8000 Advanced Console Manager User Guide - Page 285

12: User Authentication Authenticate only Select the check box to authenticate users listed in the Remote Users list in the remote users who are lower part of the page. Disabled by default. in the remote users list Deny access to remote Select the check box to authenticate remote users whose LDAP group or users assigned to TACACS+ priv_lvl map to a SLC custom group, allow SLC access if matched. groups that do not map Disabled by default. to SLC custom group 2) Continue to set Local User Passwords: Complex Passwords Allow Reuse Reuse History Password Lifetime (days) Warning Period (days) Max Login Attempts Lockout Period (minutes) Select to enable the SLC unit to enforce rules concerning the password structure (e.g., alphanumeric requirements, number of characters, punctuation marks). Disabled by default. Complexity rules: Passwords must be at least eight characters long. They must contain one upper case letter (A-Z), one lower case letter (a-z), one digit ( 0-9), and one punctuation character Select to enable users to continue to reuse old passwords. If you disable the check box, they cannot use any of the Reuse History number of passwords. Enabled by default. The number of passwords the user must use before reusing an old password. The default is 4. For example, if you set reuse history to 4, the user may reuse an old password after using 4 other passwords. The number of days until the password expires. The default setting is 90. The number of days ahead that the system warns that the user's password will expire. The default setting is 7. The number of times (up to 8) the user can attempt to log in unsuccessfully before the system locks the user out. The default setting is 0 (disabled). The number of minutes (up to 90) the locked-out user must wait before trying to log in to the web interface again. The default setting is 0 (disabled). 2. Click the Apply button. Sysadmin Account Default Login Values On factory default SLC units, the local user sysadmin account has the following default login values. SLC units manufactured after the release of SLC firmware 8.3.0.0:  username: sysadmin  password: the last 8 characters of the Device ID (ConsoleFlow ID). If the Device ID is not set, the password is the last 8 characters of the serial number. SLC units manufactured before the release of SLC firmware 8.3.0.0:  username: sysadmin  password: PASS If you don't know when the SLC unit was manufactured, you can do the following to identify whether the device-unique sysadmin password is supported and enabled on the SLC hardware. View the About SLC page or run the CLI admin version command and look for the following in SLC™ 8000 Advanced Console Manager User Guide 285