Lantronix SLC 8000 Advanced Console Manager User Guide - Page 85

6: Basic Parameters Ethernet Counters The Network > Network Settings (1 of 2) page displays statistics for each of the SLC Ethernet ports since boot-up. The system automatically updates them. Note: For Ethernet statistics for a smaller time period, use the diag perfstat command. Network Commands Go to Network Commands to view CLI commands which correspond to the web page entries described above. Ethernet Switch Some console server models support an integrated managed Ethernet Switch that can be used to connect network devices to the console manager. This switch can be used as a management LAN to provide secure access to these network devices. DHCP services are available to provide IP addresses and other network information to devices connected to the switch. The default IP address and subnet mask on the Ethernet Switch is 192.168.10.1 / 255.255.255.0. The IP address and subnet mask on the Ethernet switch can be changed via the DHCP settings. The Ethernet Switch port LEDs display the following states:  Green Light On: indicates a link at 1000 BASE-T  Green Light Off: indicates a link at other speeds, or no link  Yellow/Orange Light On: indicates a link is established  Yellow/Orange Light Blinking: indicates link activity On console server models with a managed Ethernet Switch installed, the user can:  Configure Ports and View Status: configure the speed and duplex on each port, and see the link status  View Port Statistics: view frame statistics (errors, unicast, broadcast, etc) and frame details (undersize, collisions, etc)  View MAC address table: view static and dynamic MAC address table entries To configure a switch port: 1. Click the Network tab and select the Switch option. The Network > Ethernet Switch page displays. See Figure Figure 6-4 and Figure 6-5. SLC™ 8000 Advanced Console Manager User Guide 85